BETAFPV BetaCube F4 FC Frsky Rx Z02 AIO 5.8G VTX Camera Smart Audio for Tiny Whoop Quads Like Beta75S BNF
The camera of the Betacube (Frsky version) is updated to Z02 camera while the other version of Betacube's cameras are still BETAFPV Z01 camera.
This is the upgraded version of Betacube. A customed plastic holder is made in this newest version. Soldering is done ahead of time you can use it when received. F4 FC+OSD+ Frsky Rx flight controller with AIO 5.8g newest Z02 VTX camera.
ESC: All FETs are rated at 30A maximum. Support 6x15mm/7x20mm/8x20mm/8.5x20mm etc motors.
Size: 26mm x 26mm,fully compatible with the Inductrix quad frame and mounting pattern
Firmware version: Betaflight MATEKF411RX 3.4.0
OSD: Built-in BetaFlight OSD (STM32 controls OSD chip over SPI in DMA mode)
Receiver: SPI Frsky D8 protocol (AKA FRSKY_D on Betaflight Configuration)
Power Cable: 55mm, with JST-PH 2.0 connector, AKA PowerWhoop connector
Output power: 0mW, 25mW and 200mW (Adjustable)
Supply Voltage: 2.9-5.5V
Size : 27*17*14 mm
Antenna: Omnidirectional ANT
Frequency: 5.8GHz 6 bands 48 channels, with Raceband: 5362~5945MHz
TV System: NTSC
Field of view: 100-120 degrees with 1/4 lens.
1 * BETAFPV F4 brushed flight controller (all connectors soldered)
1 * BETAFPV Z02 AIO camera VTX (all connectors soldered)
1 * Plastic Z02 Holder
4 * M1.2×4mm screws (fit for stock Inductrix frame)
4 * M1.4×5mm screws (fit for Beta75 etc 75mm frame)
4 * Amti-vibration ruber dampers
AIO stack tower with flight controller, built in long range Frsky rx, camera and 5.8g vtx for micro whoop.
The flight controller is BETAFPV F3 EVO integrated with long range Frsky rx, comes pre-flashed with Betaflight firmwa
The AIO fpv camera vtx is BETAFPV Z01 camera, 25mW 5.8g vtx module with dipole antenna
The camera is connected with vtx with 1.27mm pin headers. Bend pins to set the angle of the camera
The vtx is connected with fc board with 1.27mm pin headers too. Also get 3.7v voltage from the fc board via these pins.