BETAFPV 2S F4 FC AIO Brushless Flight Controller SPI Frsky Receiver ESC OSD Smart Audio with JST-PH2.0 Cable for 2S Brushless FPV Whoop Drone Beta75 Pro 2 Beta65 Pro 2 Beta75X Beta65X
a. Power on the board by connecting the battery or USB power. Then the green receiver LED start to flash.
b. Click the bind button for 3s. Then the green receiver LED will be solid on.
More details checking here: https://betafpv.freshdesk.com/support/solutions/articles/27000049912-f4-1s-brushless-fc-manual
Item: F4 2S AIO Brushless Flight Controller (Frsky RX+OSD+ESC)
CPU: STM32F411CEU6 (100MHZ )
Six-Axis: MPU-6000 triaxial accelerometer / triaxial gyroscope (SPI connection)
Size: 26mm x 26mm, fully compatible with the all whoop drone mounting pattern, recommend the Beta65X frame and Beta75 Pro frame.
Firmware version: betaflight_matekf411rx_4.0.0 (Development Version)
OSD: Built-in BetaFlight OSD (STM32 controls OSD chip over SPI in DMA mode)
Built in SPI Frsky D16 protocol native receiver, compatible with almost ALL Frsky FCC radios(e.g. Taranis X9D/X9D Plus/X7) or Frsky compatible transmitter module. Not compatible with Frsky LBT protocol.
Power Cable: 55mm, with 2pcs JST-PH 2.0 connector, AKA PowerWhoop connector
Built-in ESC with 5A continuous and peak 6A current
Power supply: 1-2S
Support BLHeliSuite programmable
Factory firmware: S_H_50_REV16_7.HEX
Signal Support: D-shot150, D-shot300, D-shot600, Oneshot125, Multishot, PWM
1 * F4 2S brushless flight controller
4 * M1.2x4mm screws
4 * M1.4x5mm screws
4 * Anti-vibration ruber dampers
This 2S F4 AIO FC is suitable for a lighter 2S whoop drone, like Beta65 Pro 2 or Beta75 Pro2 etc. It intergrated a Betaflight F411 processor FC, Betaflight OSD, 1-2S 5A ESC. Saving more weight for 2S drone to get faster fly experience.
The 2S F4 FC AIO Brushless Flight Controller builted without receiver, but all the ports are available on this board. Compatible receivers signal include SBUS, IBUS, Spektrum Frsky DSM2/ DSMX etc except PPM.
The power supply is 1S~2S, it comes with JST-PH 2.0 connector in default, pilots can use 2pcs 1S 300mAh battery work on this. If you want to use it with 2S battery, please change the cable to XT30 : www.amazon.co.uk/dp/B07FFQ2TXQ
This 2S F4 AIO FC is supported programable LED but without alarm buzzer on it.
This 2S F4 AIO FC also can be used on 2S brushless whoop drone Beta75X and Beta65X, performance very well even no wash-out issue then, so you can just take this AIO FC to replace the stock FC&ESC.