5in1V3 Manual English PDF:http://www.mateksys.com/downloads/5in1V3_Manual_EN.pdf
Input voltage range (3S-6S operation): 9 - 26VDC
1 Battery input andamp; 4 ESC outputs
Regulated 5V and 12V outputs
LED power indicators ( 5V andamp; 12V outputs )
4 pairs 5V LED light pads
Low voltage setting value indicators
- Dimensions: 46x36x6mm, Weight: 9g
- Mounting holes 30.5mm square spacing
F1. PDB(ESC output)
Continuous current: 20A per output
Peak current (10 seconds/minute): 25A per output
F2.BEC 5V output
Designed for RC Receivers, Flight controllers, OSD, and Servos.
DC/DC synchronous buck regulator, Efficiency is up to 95%.
Voltage: 5.0 +/- 0.1VDC
Continuous current: 3 Amps
Short-circuit tolerant (10 seconds/minute)
5V is also on the Aux pins + andamp; -.
If other 5V BEC in use, Pls remove the red wire on Aux pins.
F2.BEC 12V output
Linear regulator, very low noise.
Standard output designed to power cameras and video transmitters,etc.
Voltage: 12.0 +/- 0.3VDC (4~6S operation)
Continuous current: 500mA16V IN (Max.1A 10s/minute), 250mA24V IN
If the battery is 3S LiPo, Output voltage=3S LiPo voltage - 1V
Don't use the BEC 12V to power VTX or Gimbals when 6S battery is in use.
F3. LED Light Controller
F4.Lost Plane Finder
F5. Low Voltage Alarm
1 * Crazepony Matek Version3 5in1 Power Distribution Board for 180 250 210 Racing Multirotor Quadacopter
Specially made for the Multi-Rotors,mini FPV Quad.Dimension:46*36*6mm,net weight:8.84g
It is a V3 version 5in1 HUB with Power Distribution Board,BEC 5V/3A 12V/500mA,LED Light Controller,Lost Plane Finder Low Voltage Alarm functions.
2oz copper 4-layers PCB,ESC Battery solder tabs in pairs.TVS input protection.
Built-in 5V BEC can be connected to receiver or flight controller with Aux pins directly.Simplify wiring.The BEC 12V can be used to power the Camera,Video Transmitters,ect.
Inbuild 5V LED light controller,three flash modes can be choosed with the toggle switch of transmiter.