BETAFPV F4 1S Brushless Flight Controller FPV FC Integrated with ESC OSD Support SmartAudio (No RX) for 1S FPV Micro Brushless Racing Drone like Beta75 pro Beta65 pro
CPU: STM32F411CEU6 (100MHZ)
Six-Axis: MPU-6000 triaxial accelerometer / triaxial gyroscope (SPI connection)
Size: 26mm x 26mm, fully compatible with the Inductrix quad frame, BWhoop B06 frame and mounting pattern
Firmware version: betaflight_3.5.0_MATEKF411.hex
OSD: Built-in BetaFlight OSD (STM32 controls OSD chip over SPI in DMA mode)
Power Cable: 55mm, with JST-PH 2.0 connector, AKA PowerWhoop connector
Power supply: 1S
Current: 5A continuous and peak 6A (3 seconds)
Support BLHeliSuite programmable
Factory firmware: O_L_5_REV16_6.HEX
Signal Support: D-shot150, D-shot300, D-shot600, Oneshot125, Multishot, PWM
Recommend Parts List
Beta65 Pro frame-www.amazon.co.uk/dp/B078GLW4HK
Beta75 Pro frame-www.amazon.co.uk/dp/B078H7R3PV
31mm 4-Blades props (for Beta65 Pro)-www.amazon.co.uk/dp/B07D7WSL3L
40mm 4-blades props (for Beta75 Pro)-www.amazon.co.uk/dp/B07B2P7TF4
Receiver: XM Receiver / XM+Receiver / Fullspeed DSMX Receiver / Futaba RX800-PRO Receiver / Flysky RX2A Pro Receiver
1 * F4 1S brushless flight controller
4 * M1.2x4mm screws
4 * M1.4x5mm screws
4 * Anti-vibration ruber dampers
This is upgraded F4 Brushless FC No RX based on F3 version, MCU has upgraded to STM32F411 100MHz with faster processing rate(from 72MHz to 100MHz). Build-in Betaflight OSD and polar reversed protection. Suitable for 1S brushless whoop drone Beta65 Pro, Beta75 Pro, BWhoop B06 etc.
High-performance ST Microelectronics ARM Cortex-M4 core F411 100MHz CPU (safely overclocked to 120MHz).30A continuous drain current MOSFET. Lower to 8.5m? inner resistance value (4.5V). It has a noticeable power improvement in low battery voltage status or with 8x20/8.5x20 motors.
The F4 1S brushless FC comes with no receiver, compatible receivers signal include PPM, SBUS, IBUS, Spektrum DSM2 / DSMX, 1024/2048 etc. The flight controller board comes pre-flashed with Betaflight firmware.
Fully programmable through Betaflight firmware, using the onboard USB port, tune all the parameters, PID's, and rates to your perfect settings.
The output voltage for receiver is switchable between 3.3V and 5V. So pilots could use Spektrum receiver that need 3.3V power. 3.3V in default. Built in ESC support 5A continuous current and peak 6A (3 seconds), support BLHeliSuite programmable.Some basic guidance and typical FAQ, please check it here : https://betafpv.freshdesk.com/support/solutions